ADM Masonry LLC provides licensed roof installation, repair, and replacement services for residential and commercial properties across New Jersey. Our crew handles shingle, flat, and low-slope roofing systems — delivering weather-tight protection that performs through every season.
New Jersey's roofing environment is one of the most demanding in the northeastern United States. The state experiences the full range of weather stressors — summer heat exceeding 95 degrees Fahrenheit, winter temperatures below zero, nor'easter wind-driven rain, ice dams along eaves from freeze-thaw cycling, and hurricane-remnant storm systems tracking up the coast in late summer and fall. A roofing system that is not specified and installed correctly for this exposure profile will fail prematurely, allowing water infiltration that damages insulation, sheathing, and interior finishes.
ADM Masonry LLC provides roof installation, repair, and full replacement services for residential and commercial properties throughout New Jersey. Our roofing scope covers asphalt shingle roofs, flat and low-slope roofing systems using TPO and modified bitumen membranes, and flashings at all roof-wall intersections, chimneys, skylights, and penetrations. Every project begins with a roof inspection to document the condition of the existing system and identify all areas requiring attention before repair or replacement is recommended.
Roofing work integrates directly with ADM Masonry LLC's chimney and masonry expertise — an advantage for New Jersey property owners whose roof leaks originate at the chimney flashing, masonry parapet walls, or masonry facade penetrations. Our crew manages both the roofing membrane and the masonry interface as a single scope, eliminating the coordination failures that occur when separate roofing and masonry contractors cannot agree on whose responsibility a flashing leak belongs to.
Full roof replacement begins with a complete tear-off of the existing roofing materials down to the sheathing. ADM Masonry LLC inspects the sheathing for rot, delamination, and structural deficiencies, replacing any damaged sections before new roofing materials are applied. Ice and water shield membrane is installed at all eaves, valleys, and penetrations — a minimum of 24 inches inside the heated wall line — to prevent ice dam water infiltration during New Jersey winters.
Asphalt shingles for New Jersey residential roofing are specified at a minimum 30-year architectural grade, with Class 4 impact resistance ratings recommended for areas of New Jersey subject to hail exposure. Starter strip shingles are installed at the eaves and rakes before field shingles begin, providing a sealed edge that prevents wind-driven rain from entering under the first course. Each shingle course is fastened with the correct number and pattern of roofing nails — typically four to six nails per shingle.
Flat and low-slope roofing for commercial buildings, row house rooftops, and additions in New Jersey typically uses TPO single-ply membrane or self-adhered modified bitumen. TPO provides excellent UV resistance and reflectivity — reducing cooling loads in New Jersey summers — and is welded at seams using hot-air equipment that creates a bond stronger than the membrane itself. Modified bitumen is torch-applied in two or three layers, providing a redundant waterproofing system suitable for high-traffic rooftop surfaces.
Roof leaks in New Jersey are rarely simple. Water that enters the roofing system at one point can travel along the sheathing, rafters, or insulation before manifesting as a stain on an interior ceiling some distance from the actual entry point. ADM Masonry LLC performs systematic leak investigations — starting from the point of interior water damage, tracing upward through the insulation and sheathing, and identifying the actual entry point — before any repair is made.
Common roof repair conditions in New Jersey include lifted or missing shingles from wind damage, cracked or missing flashing at chimneys and skylights, failed pipe boot seals at plumbing penetrations, and granule loss from aged shingles. ADM Masonry LLC performs targeted repairs to address specific damage conditions without requiring full replacement when the surrounding roof system is in sound condition.
Ice dam damage is a recurring issue in New Jersey homes with inadequate attic insulation and ventilation. ADM Masonry LLC addresses ice dam conditions by repairing the immediate water damage, installing ice and water shield in the affected eave zones, and providing recommendations for attic insulation and ventilation improvements that reduce the temperature differential driving ice dam formation. The roofing repair addresses the symptom; the attic improvement addresses the cause.
Flashings are the most failure-prone components of any roofing system and the most frequent source of water infiltration in New Jersey residential properties. Step flashing must be installed shingle-by-shingle as the shingle courses are laid. Counter flashing embedded in the mortar joints of masonry walls or chimneys seals the top of the step flashing against the wall. Both must be correctly formed and lapped to shed water without gaps.
Chimney flashings in New Jersey deteriorate from the combined effects of thermal movement and freeze-thaw cycling of the mortar joints into which the counter flashing is embedded. ADM Masonry LLC replaces chimney flashings using corrosion-resistant metal, embeds counter flashing in freshly repointed mortar joints, and seals all terminations with a high-temperature rated flexible sealant. This approach addresses the flashing, the mortar, and the seal in a single integrated repair.
Roof penetrations — plumbing vents, exhaust fans, skylights, and HVAC equipment curbs — each require correctly sized and installed flashing systems. Pipe boot seals made from EPDM rubber degrade in UV exposure and typically require replacement every 10 to 15 years in New Jersey's climate. ADM Masonry LLC replaces all deteriorated pipe boots during roof replacement and as targeted repairs on aging roofs where the membrane remains serviceable but the boots have failed.
ADM Masonry LLC is based in Newark, NJ and serves residential and commercial clients throughout Essex, Hudson, Union, Bergen, and Passaic counties. Our licensed crew is available for projects large and small across the state.
Request a free estimate for your New Jersey project. Our licensed crew provides clear written quotes with no obligation.
